2. Razor
  3. W15110710048
W15110710048

Razor W15110710048 User manual

  • Hello! I have reviewed the provided user manual for the Razor Motor-Rear Wheel W15110710048. This document includes detailed steps for replacing the rear wheel motor, along with important safety warnings and a list of required tools. I am here to answer any questions you might have regarding this replacement procedure.
  • What tools are required for the replacement?
    What should I do before starting the replacement?
    How long should I charge the battery after installation?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Two (2) 19 mm wrenches
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove two (2) screws from
the battery cover on the right side of the unit.
Locate and disconnect the motor connectors from the
controller.
VECTOR MOTOR-REAR WHEEL
REPLACEMENT PROCEDURES
PART # W15110710048
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Using two (2) 19 mm wrenches, loosen the lock nuts from
the rear axle and slide the wheel down.
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
Cut the zip-tie that holds the motor cable onto the frame
and slide the cable out from the frame.
/