INSTRUCTIONS
2” TRIM DOWNLIGHTS INSTALLATION
RAB Lighting is committed to creating high-quality, aordable, well-designed and energy-ecient LED lighting and controls that make it easy for electricians to install
and end users to save energy
. W
e’
d love to hear your comments. Please call the Marketing Depar
tment at 888-RAB-1000 or email:
[email protected]IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING: Make certain power is OFF before installing or maintaining xture.
WARNING: Suitable for wet location with covered ceiling mount.
WARNING: Suitable for installation in Non-Accessible and Accessible Ceilings.
WARNING: Suitable for installation in Non-Insulated Ceilings.
1. Nailer Bars
2. Buttery Brackets(optionally available,
consult factory)
3.
Wing NutButtery Bracket
Wing Nut
Buttery Bracket (Fig. 1).
4. Buttery Brackets
Rough-In Section
Wing Nuts
5. Supply Wire
6. Junction Box ScrewJunction Box (Fig.2)
Supply Wires Junction Box
7. Junction Box
Spring ClipsTrim Ring
Junction Box Leg
Rough-in Section
Buttery Brackets
Nailer Bar
Wing Nut
Downturn Collar
Rough-in
Section
Leg
Supply wires
Junction Box
Screw
Junction Box
Trim Ring
Spring Clip
RDDLED2R RDDLED2S
•
•
•
CEILING CUT OUT MUST BE FREE OF ANY DEBRIS AND BURRS.