2. BLOTZ
  3. B20-ST-102

BLOTZ B20-ST-102, B20-ST-103, B20-ST-104, B20-ST-105, B20-ST-106, B20_ST_102, B20_ST_103, B20_ST_104, B20_ST_105, B20_ST_106 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ 20mm scale model sheds, specifically models #1, #2, #3, #4 and the shed pack. This document outlines the assembly process, including the tools and materials you'll need. I'm ready to answer your questions about building these sheds.
  • What type of glue is required for assembly?
    What kind of tool is needed to remove parts from the sprue?
    What can be used to hold pieces in place while glue dries?
20mm Sheds (#1, #2, #3, #4 and shed pack)
B20-ST-102 / 103 / 104 / 105 / 106
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Shed #1 (B20-ST-102)
Remove the two sides, base, front and rear of the shed
from the sprue.
Glue the sides and rear to the base.
Glue the front into position.
Take the pieces of the roof.
Glue the supports to the back of one roof section.
Then glue the other roof section into place.
Place or glue the roof onto the body of the shed.
Shed #2 (B20-ST-103)
Remove the two sides, base, front and rear of the shed
from the sprue.
Glue the sides and rear to the base.
Glue the front into position.
Take the pieces of the roof.
Glue the supports to the back of one roof section.
Then glue the other roof section into place.
Place or glue the roof onto the body of the shed.
Shed #3 (B20-ST-104)
Remove the two sides, base, front and rear of the shed
from the sprue.
Glue the sides and rear to the base. The higher point
of the end should be against the side with the
window in it.
Glue the front into position.
Take the pieces of the roof.
Glue the support to the back of the roof as shown.
Then glue or place the roof section into position..
Shed #4 (B20-ST-105)
Remove the two sides, base, front and rear of the shed
from the sprue.
Glue the sides and rear to the base.
Glue the front into position.
Take the pieces of the roof.
Glue the support to the back of the roof as shown
above.
Then glue or place the roof into position.
/