BLOTZ B28-OW-602 Assembly Instructions

  • Hello! I've reviewed the instructions for the Old West Roof #3 model. This document details the step-by-step process for assembling the roof, from removing the inner walls to adding the roof strips. It specifies needed materials like PVA or equivalent glue and tools, such as a sharp modeling knife. I'm here to assist with any questions you might have regarding the construction of your model.
  • What type of glue is required for assembly?
    What tool is needed to remove sections from the sprue?
    Can sandpaper be used during assembly?
28mm Old West Roof #3
B28-OW-602
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the inner walls from the sprue.
Glue them together to form a square (see pic)
Turn the square upside down and glue it to the back of
the roof piece. It will be flush at one end and extend
out at the other.
The outer frames.
Glue a frame to each side.
And the strip to the thin end (aligning to the bottom
of the inner piece).
Add the insert pieces
The roof strips.
Glue these into position.
The completed roof.
/