Extron Angle Mount Kits Template

Alignment Template for the Extron

AMK 2 and AMK 3

(for mounting TLS Pro 725M, TLP Pro 725M, TLS Pro 1025M, and TLP Pro 1025M)

Page size: 11" x 17"

Print scale 1:1

Do not shrink.

1. See the Extron AMK 1, AMK 2, and

AMK 3 Installation Guide for

complete instructions.

2. Double-check the print settings

before printing. Make sure the scale

settings are 1:1.

3. After printing, check that the bottom

edge of the AMK rear panel.

(solid red line) is 4.58" (116 mm).

P/N 68-3423-02 Rev. A

CATx cable entry

2.38"

(60 mm)

Outer edge of

TLS Pro 725M

Adhesive Patch Outer edge of

TLS Pro 1025M

Bottom edge of AMK 2 and AMK 3 rear panel

(see AMK 1, AMK 2, and AMK 3 Installation Guide)

Top edge of AMK 2 and AMK 3 rear panel

(see AMK 1, AMK 2, and AMK 3 Installation Guide)

This manual is also suitable for