Cut-out Template for the Extron
TLP Pro 725M, TLS 725M, and TLC Pro 726M Series
SURFACE
CUT-OUT
AREA
3.50" (89 mm)
2.00"
(51 mm)
Page size: 8.5" x 11"
Print scale 1:1
Do not shrink.
P/N 68-3206-01 Rev. B
1. Confirm the product to be
installed.
2. Before printing, double-check the
print settings and make sure the
page is not scaled.
3. After printing, measure the gray
dotted line to make sure it has
the dimensions shown.
4. Cut the red line and remove the
surface cut-out area (gray) from
the template.
5. Place the template. Use a level to
ensure it is at the correct angle
and make sure that there is
enough room for the touchpanel.
6. Mark the position on the
mounting surface where the
touchpanel is being installed.
7. Double-check dimensions and
position, then cut the opening.
For complete installation instructions,
see the TLP Pro 525M, 725M, and
1025M Series Setup Guide or TLC Pro
526M, 726M, and 1026M Series Setup
Guide (at www.extron.com).
Outer edge of touchpanel (Do not cut)
5.05" H x 7.12" W (128 mm H x 181 mm W)
-
1
Extron TLS 725M Template
- Type
- Template
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Extron Angle Mount Kits User manual
-
-
-
Extron TLE 350 Template
-
Extron TLS 525M Template
-
Extron electronics TSP Series User manual
-
Extron electronics TLC Pro 1026M User manual
-
-
Extron electronics SMK 2 User manual
-
Extron electronics TLCA 1 User manual
