7.25"
(184.2 mm)
0.825"
(21.0 mm)
0.825"
(21.0 mm)
11.00" (279.4 mm)
Page size: 11" x 17"
Print scale 1:1
Do not shrink.
SURFACE
CUT-OUT
AREA
6.25"
(158.8 mm)
9.25" (235.0 mm)
0.88"
(22.4 mm)
0.12"
(3.0 mm)
P/N 68-3575-01
Rev. A
The top left corner of this page aligns with the top left corner of the TLP Pro 1725MG bezel.
The bottom and right edges of the TLP Pro 1725MG bezel extend beyond the bottom and right edges of the paper.
Cut-Out Template for the Extron
TLP Pro 1725MG
1. Confirm the product to be installed.
2. Before printing, check the print settings
and make sure the page is not scaled.
3. After printing, measure the cut-out area (gray)
and ensure it matches the dimensions shown
on this template.
4. Remove the surface cut-out area from the
template. (Keep these instructions.)
5. Use this template to mount the TLP Pro 1725MG.
For complete instructions, see the product
Setup Guide or User Guide.
/
