Cut-out Template for the Extron
TLP Pro 1025M, TLS 1025M, and TLC Pro 1026M Series
1. Confirm the product to be installed.
2. Before printing, double-check the
print settings and make sure the page
is not scaled.
3. After printing, measure the gray dotted
line to make sure it has the dimensions
shown.
4. Cut the red line and remove the surface
cut-out area (gray) from the template.
5. Place the template. Use a level to ensure
it is at the correct angle and make sure
that there is enough room for the
touchpanel.
6. Mark the position on the mounting surface
where the touchpanel is being installed.
7. Double-check dimensions and position,
then cut the opening.
For complete installation instructions,
see the TLP Pro 525M, 725M, and 1025M
Series Setup Guide or TLC Pro 526M,
726M, and 1026M Series Setup Guide (at
www.extron.com).
P/N 68-3331-01 Rev. B
Page size: 11" x 17"
Print scale 1:1
Do not shrink.
Outer edge of Touchpanel (Do not cut)
6.84" H x 10.13" W (174 mm H x 257 mm W)
SURFACE
CUT-OUT
AREA
3.50" (89 mm)
2.00"
(51 mm)
-
1
Extron TLS 1025M Template
- Type
- Template
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Extron TLS 725M Template
-
-
-
Extron TLE 350 Template
-
Extron TLS 525M Template
-
Extron electronics TSP Series User manual
-
Extron electronics TLC Pro 1026M User manual
-
-
Extron electronics TLCA 1 User manual
-
Extron electronics SMK 2 User manual
