28mm Wild West School Furniture
B28-AF-101
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
For the table, remove the pieces shown above
from the sprue. First apply a little glue to the top
bar of the two end pieces and stick to the table
top, aligning the holes / lugs.
Secondly, apply a little glue to each end of the bar and
attach to the notches in the end pieces.
The chair is formed from the pieces shown
above. Apply a little glue to the underside of one
short end of the seat. Stick this to the top of the
bar on the chair back.
Apply glue to the underside of the other end of the
seat and attach the front legs.
The bookcase is formed from the pieces shown
above. Firstly apply glue to one shelf and insert it
into the central hole. Use this to align the two
end pieces.
Finally insert the lower shelf and top shelf.
Each desk is formed from the pieces shown
above.
Start by attaching the backrest and seat to one end of
the desk.
Then using the lugs, align the other end of the
desk.
Finally attach the writing slope and lower bar.
The wall mounted blackboard is formed from the
pieces shown above.
Simply glue the bar to the bottom of the blackboard so
that you have a small lip protruding from the front of
the board.
The easel is made from the pieces shown above.
Apply a little glue to the lug on the rear leg and arrach
to the front legs. Stick the cross bar into place.
The piano is formed from the pieces shown
above.
Start by attaching the keyboard to the front of the
piano, then glue the ends in place.
Attach the base and top of the piano.
Finally attach the back.
/
