Razor W15128785023 User manual

Brand: Razor

Model: W15128785023

Type: User manual

Razor W15128785023: Experience effortless rides with this front fork-headset bearing replacement kit, designed to restore smooth steering and control to your compatible Razor electric scooter. Enhance your riding experience and ensure continued safety with this easy-to-install replacement part.

Razor W15128785023: Experience effortless rides with this front fork-headset bearing replacement kit, designed to restore smooth steering and control to your compatible Razor electric scooter. Enhance your riding experience and ensure continued safety with this easy-to-install replacement part.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

1

WARNING

Step 1 Step 2

Required Tools: (Not included)

A. 6 mm Allen wrench

B. Phillips screwdriver

C. 36 mm wrench or an adjustable wrench

D. 5 mm Allen wrench

E. 10 mm crown wrench

F. Two (2) 15 mm socket wrenches

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Using a 6 mm Allen wrench, remove the four (4) bolts

from the handlebar clamps and set handlebar aside.

Remove the plug on top of the headset lock nut. Using a

Phillips screwdriver, remove the two (2) screws from the

headlamp holder.

RAMBLER 16 FRONT FORK-HEADSET BEARINGS

REPLACEMENT INSTRUCTIONS

PART # W15128785023/W15128701023

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

2

Step 3 Step 4

Using a 36 mm wrench or an adjustable wrench, loosen

and remove the headset lock nut from top of the fork.

Using a 5 mm Allen wrench and a 10 mm crown wrench,

insert the crown wrench inside the fork tube to hold the

lock nut. With the 5 mm Allen wrench, loosen and remove

the limiter bolt.

Using a Phillips screwdriver, remove two (2) screws from

the limiter cover and remove the cover.

Using a 5 mm Allen wrench, loosen and remove the two

(2) hex bolts that hold the upper fork crown onto the fork

and remove it. Slide the front fork down and out the frame.

If replacing the headset bearings, just remove and replace.

No need to remove the front wheel.

Step 5 Step 6

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

3

Step 7 Step 8

Using two (2) 15 mm socket wrenches, loosen the lock

nuts from the front axle and slide the wheel down.

Reverse the steps.

ATTENTION: Charge battery 12 hours before using.

1
2
3

Razor W15128785023 User manual

Brand: Razor

Model: W15128785023

Type: User manual

Razor W15128785023: Experience effortless rides with this front fork-headset bearing replacement kit, designed to restore smooth steering and control to your compatible Razor electric scooter. Enhance your riding experience and ensure continued safety with this easy-to-install replacement part.

Related papers

Other documents

Razor&#174 15130661 Owner's manual