2. Razor
  3. Power A2

Razor Power A2 User manual

  • Hello! I've reviewed the user manual for the Razor A2 rear wheel replacement, specifically model W13110002048. This document includes crucial steps for safely replacing the wheel and motor, detailing all required tools and providing clear instructions for each stage. I'm ready to help answer any questions you have about this process.
  • What tools are needed for the rear wheel replacement?
    How many screws need to be removed from the controller cover?
    How many motor connectors need to be disconnected?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Blade or knife
C. 3 mm Allen wrench
D. 5 mm Allen wrench
E. Small flat screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove four (4) screws from
the controller cover under the deck.
Locate and disconnect two (2) motor connectors from
controller.
POWER A2 REAR WHEEL WITH MOTOR
REPLACEMENT PROCEDURES
PART # W13110002048
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Disconnect brake cable from controller.
Using a 3 mm Allen wrench, remove two (2) screws from
the brake fender.
Using a blade or knife, cut the grip tape shown in picture.
Peel the grip tape to the side.
Using a 5 mm Allen wrench, remove the bolts that hold
the wheel in place.
Step 5 Step 6
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
3
Step 7 Step 8
Step 9
Using a small flat screwdriver, remove the grommet at
the back from inside the controller compartment.
Once you remove the grommet, slide rear wheel and
fender off from the unit being careful not to pinch the
wires.
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
/