Razor W15110710063 Operating instructions

Type
Operating instructions
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Two (2) 19 mm wrenches
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove two (2) screws from
the battery cover on the right side of the unit.
Locate and disconnect the rear fender light from the
controller.
VECTOR REAR FENDER
REPLACEMENT PROCEDURES
PART # W15110710063
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Using two (2) 19 mm wrenches, loosen the lock nuts from
the rear axle and slide the wheel down.
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
Using a Phillips screwdriver, loosen and remove the two
(2) screws that hold the rear fender onto the frame. Slide
the cable and rear fender out from the frame.
  • Page 1 1
  • Page 2 2

Razor W15110710063 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI