2. AMG
  3. AMG2285S

AMG AMG2285S Instruction Sheet

  • Hello! I have read the AMG Instruction Sheet for the Video Transceiver SYSTEM 2000 AMG2285S. This document provides information on the device's connections, including video, optical, and data. It also covers power requirements and physical dimensions, as well as key features like bi-directional audio. I am ready to answer any questions you might have about the device based on this information.
  • What type of video connector does the device use?
    What type of optical connector does the device use?
    What is the input voltage range for the device?
    What is the audio connection type?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D04096-02
AMG2285S
Instruction Sheet
AMG2285S Single Fibre Standalone Video Transmit + Bi-directional Audio
Video Connection
Connectors ...........................75 ohm BNC Socket.
Input Impedance...................75 ohm terminated.
Input Level ...........................1 volt p-p nominal.
Frequency Response.............10Hz to 6MHz min.
Optical Connection
Connector .............................ST Style (1 off)
Opto Out Launch Power
50/125............................-20dBm. min.
62.5/125.........................-17dBm min.
Wavelength...........................850/1300nm (single fibre) nominal.
Data Connection
Connector .............................Push-in connector strip- 14way
(Solid conductors 0.5mm2(20 awg) can be connected by simply push fitting
into the appropriate connection hole. Smaller conductors and wires (up to
0.5mm2, 20 awg) are inserted into the connection space whilst depressing the
orange lever. Wire or conductors should be stripped back to a length of
11mm. Use a small screwdriver to depress the orange lever to release the
connection.)
VIDEO INPUT Opto OUT
(Single Fibre not fitted
Opto IN
(IN/OUT Single Fibre)
SYSTEM 2000
Video
Transceiver
134mm
148mm
7mm
39.5mm
79mm A A
PL1
PIN 1
PIN 14
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D04096-02
Pinout ...................................See Below – Note Pins number from the BNC connector
Pin No. Function
1 N/C
2 N/C
3 Power Ground
4 Power Input (+12v to +18v dc )
5 Audio Ground
6 Audio Input
Data
Interface
7 N/C
8 N/C
9 N/C
10 N/C
11 N/C
12 Audio Ground
13 Audio Output (+)
14 Audio Output (-)
Power Supply
Supply...................................+12 volt to +18 volt at 250mA
Connection ...........................Connector Strip
Pin 3 Gnd, Pin 4 Power Input
Dimensions
See Drawing Above
Mounting Details
See Drawing Above
/