2. AMG
  3. AMG2245S

AMG AMG2245S Instruction Sheet

  • Hello! I've analyzed the Instruction Sheet for the SYSTEM 2000 AMG2245S Video Transceiver. This document details the device's video, audio, and contact closure capabilities, including various connection options and specifications. I am ready to answer your questions about the information contained in this document.
  • What type of connector is used for video input?
    What is the input impedance for the video connection?
    What is the nominal video input level?
    What type of connector is used for optical connection?
    What type of connector is used for data connection?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D04074-02
AMG2245S
Instruction Sheet
AMG2245S Single Fibre Standalone Video Transmit + Bi-directional Audio + Contact
Closure
Video Connection
Connectors ...........................75 ohm BNC Socket.
Input Impedance...................75 ohm terminated.
Input Level ...........................1 volt p-p nominal.
Frequency Response.............10Hz to 6MHz min.
Optical Connection
Connector .............................ST Style (1 off)
Opto Out Launch Power
50/125............................-20dBm. min.
62.5/125.........................-17dBm min.
Wavelength...........................850/1300nm (single fibre) nominal.
Data Connection
Connector .............................Push-in connector strip - 14way
(Solid conductors 0.5mm2(20 awg) can be connected by simply push fitting
into the appropriate connection hole. Smaller conductors and wires (up to
0.5mm2, 20 awg) are inserted into the connection space whilst depressing the
orange lever. Wire or conductors should be stripped back to a length of
11mm. Use a small screwdriver to depress the orange lever to release the
connection.)
VIDEO INPUT Opto OUT
(Single Fibre not fitted
Opto IN
(IN/OUT Single Fibre)
SYSTEM 2000
Video
Transceiver
134mm
148mm
7mm
39.5mm
79mm A A
PL1
PIN 1
PIN 14
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D04074-02
Pinout ...................................See Below – Note Pins number from the BNC Connector
Pin No. Function
1 NC
2 NC
3 Power Ground
4 Power Input (+12v to +18v dc )
5 Ground
6 Audio Input
Data
Interface Contact Closure
7 Out Common
8 Out N/C
9 Out N/O
10 Contact In
11 Contact Ground
12 Audio Ground
13 Audio Output (+)
14 Audio Output (-)
Power Supply
Supply...................................+12 volt to +18 volt at 250mA
Connection ...........................Connector Strip
Pin 3 Gnd, Pin 4 Power Input
Dimensions
See Drawing Above
Mounting Details
See Drawing Above
/