2. AMG
  3. AMG2242S

AMG AMG2242S, AMG2242 Instruction Sheet

  • Hello! I've reviewed the Instruction Sheet for the AMG Video Transceiver SYSTEM 2000 AMG2242S. This document details the device's video, audio, and data transmission capabilities, as well as its optical and electrical connection options. I'm ready to answer any questions you have about its specifications or usage.
  • What type of video connector does this device use?
    What is the optical connector type?
    What are the power supply requirements for this device?
    What type of data connection does this device have?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D03702-00
AMG2242S
Instruction Sheet
AMG2242S Standalone Video Transmit + Bi-directional Audio + Data RS232
Video Connection
Connectors ...........................75 ohm BNC Socket.
Input Impedance...................75 ohm terminated.
Input Level ...........................1 volt p-p nominal.
Frequency Response.............10Hz to 6MHz min.
Optical Connection
Connectors............................ST Style (1 off)
Opto Out Launch Power
50/125............................-20dBm. min.
62.5/125.........................-17dBm min.
Wavelength...........................850nm nominal.
Data Connection
Connector .............................Push-in connector strip - 14way
(Solid conductors 0.5mm2(20 awg) can be connected by simply push fitting
into the appropriate connection hole. Smaller conductors and wires (up to
0.5mm2, 20 awg) are inserted into the connection space whilst depressing the
orange lever. Wire or conductors should be stripped back to a length of
11mm. Use a small screwdriver to depress the orange lever to release the
connection.)
VIDEO INPUT Opto OUT
(Single Fibre not fitted
Opto IN
(IN/OUT Single Fibre)
SYSTEM 2000
Video
Transceiver
134mm
148mm
7mm
39.5mm
79mm A A
PL1
PIN 1
PIN 14
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D03702-00
Pinout ...................................See Below – Note Pins number from the BNC connector
Pin No. Function
1 NC
2 NC
3 Power Ground
4 Power Input (+12v to +18v dc )
5 Ground
6 Audio Input
Data
Interface RS232
7 Data Ground
8 Data Out
9 Data In
10 N/C
11 N/C
12 Audio Ground
13 Audio Output (+)
14 Audio Output (-)
Power Supply
Supply...................................+12 volt to +18 volt at 250mA
Connection ...........................Connector Strip
Pin 3 Gnd, Pin 4 Power Input
Dimensions
See Drawing Above
Mounting Details
See Drawing Above
/