2. AMG
  3. AMG2265S

AMG AMG2265S Instruction Sheet

  • Hello! I've reviewed the provided instruction sheet for the AMG SYSTEM 2000 AMG2265S single fiber video transceiver. This document details the device's specifications, connections, and key features, including its single fiber transmission, bi-directional contact closure, and various power and connection requirements. I am now ready to answer any questions you might have about this device.
  • What type of connector is used for video input?
    What is the optical connector type?
    What is the power supply requirement for the device?
    What is the data connector type?
    What is the input level for the video signal?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D035102-02
AMG2265S
Instruction Sheet
AMG2265S Single Fibre Standalone Video Transmit + Bi-directional Contact Closure
Data
Video Connection
Connectors ........................... 75 ohm BNC Socket.
Input Impedance................... 75 ohm terminated.
Input Level ........................... 1 volt p-p nominal.
Frequency Response............. 10Hz to 6MHz min.
Optical Connection
Connectors............................ ST Style (1 off)
Opto Out Launch Power
50/125............................ -20dBm. min.
62.5/125......................... -17dBm min.
Wavelength........................... 850/1300 (single fibre) nm nominal.
Data Connection
Connector ............................. Push-in connector strip - 14way
(Solid conductors 0.5mm2 (20 awg) can be connected by simply push fitting
into the appropriate connection hole. Smaller conductors and wires (up to
0.5mm2, 20 awg) are inserted into the connection space whilst depressing the
orange lever. Wire or conductors should be stripped back to a length of
11mm. Use a small screwdriver to depress the orange lever to release the
connection.)
VIDEO INPUT Opto OUT
(Single Fibre not fitted
Opto IN
(IN/OUT Single Fibre)
SYSTEM 2000
Video
Transceiver
134mm
148mm
7mm
39.5mm
79mm
A
A
PL1
PIN 1
PIN 14
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D035102-02
Pinout ................................... See Below – Note Pins number from the BNC connector
Pin No. Function
1 N/C
2 N/C
3 Power Ground
4 Power Input (+12v to +18v dc )
5 Ground
6 N/C
Data
Interface
Contact
Closure
7 Out Common
8 Out N/C
9 Out N/O
10 Contact In
11 Ground
12 Ground
13 N/C
14 N/C
Power Supply
Supply................................... +12 volt to +18 volt at 250mA
Connection ........................... Connector Strip
Pin 3 Gnd, Pin 4 Power Input
Dimensions
See Drawing Above
Mounting Details
See Drawing Above
/