2. AMG
  3. AMG2261-5

AMG AMG2261-5 Instruction Sheet

  • Hello! I've reviewed the Instruction Sheet for the AMG Video Transceiver SYSTEM 2000 AMG2261/5. This document covers the device's video and optical connections, data interfaces, and power requirements. I'm ready to answer your questions about the device, including its features like the 75 ohm BNC video input, ST style optical connectors, or the 14-way data connector. How can I assist you today?
  • What type of video connector does this device use?
    What type of optical connector does the device use?
    What is the input impedance for video connection?
    What is the nominal video input level?
    What type of power supply does the device require?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D04207-00
AMG2261/5
Instruction Sheet
AMG2261/5 Standalone Video Transmit + Data Rx, Contact Closure Data TX
Video Connection
Connectors ...........................75 ohm BNC Socket.
Input Impedance...................75 ohm terminated.
Input Level ...........................1 volt p-p nominal.
Frequency Response.............10Hz to 6MHz min.
Optical Connection
Connectors............................ST Style (2 off)
Opto Out Launch Power
50/125............................-20dBm. min.
62.5/125.........................-17dBm min.
Wavelength...........................850nm nominal.
Data Connection
Connector .............................Push-in connector strip- 14way
(Solid conductors 0.5mm2(20 awg) can be connected by simply push fitting
into the appropriate connection hole. Smaller conductors and wires (up to
0.5mm2, 20 awg) are inserted into the connection space whilst depressing the
orange lever. Wire or conductors should be stripped back to a length of
11mm. Use a small screwdriver to depress the orange lever to release the
connection.)
VIDEO INPUT Opto OUT
(Single Fibre not fitted
Opto IN
(IN/OUT Single Fibre)
SYSTEM 2000
VIDEO
TRANSCEIVER
134mm
148mm
7mm
39.5mm
79mm A A
PL1
PIN 1
PIN 14
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D04207-00
Pinout ...................................See Below – Note Pins number from the BNC connector
Pin No. Function
1 N/C
2 N/C
3 Power Ground
4 Power Input (+12v to +18v dc )
5 Ground
6 N/C
Data
Interface
7 Data GND
8 RS422 out (A)+
9 RS422 In (B)-
10 Contact In
11 Contact GND
12 N/C
13 N/C
14 N/C
Power Supply
Supply...................................+12 volt to +18 volt at 250mA
Connection ...........................Connector Strip
Pin 3 Gnd, Pin 4 Power Input
Dimensions
See Drawing Above
Mounting Details
See Drawing Above
/