Page is loading ...
Parts :
A: Tabletop
E: Footrest
B: Base
C: Glides
Quantity: 4
IMPORTANT NOTICE:
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have all parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
G: Long Bolt
H: Short Bolt
I: Screw
Quantity: 2
Quantity: 2
Quantity: 6
D: Center Post
Organize your parts. You will need a phillips screwdriver.
Brody Sit-Stand Desk • 1900 • INSTRUCTIONS
F: Hex Key
A
B
C
E
D
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
STEP 2 : Attach Base(B) to assembled portion using Long Bolts(G). Make sure legs and front of tabletop are facing the same way.
STEP 1 : Choose side you wish to use for your Tabletop(A). Using Screws(H) attach Center Post(D) to of underside of Tabletop(A).
See
gure 1
for placement.
NOTE: You may have to tap in Long Bolts(G) with a rubber mallet.
NOTE: Make sure lever of Center Post(D) is facing rear of desk. Figure 1
Brody Sit-Stand Desk • 1900 • INSTRUCTIONS
A
D D
I
Lever
Front
Rear
I
B
B
G
G
9”
9”
3”
Organize your parts. You will need a phillips screwdriver.
Front
Rear
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
STEP 4 : Using Short Bolts(H) and Hex Key(F) Attach Footrest(E) to pre-existing holes on bottom of Center Post(D) (See gure 1.)
Make sure Footrest(E) is parallel to ground.
STEP 3 : Attach Glides(C) to bottom of Base(B ). Flip right side up once complete.
Brody Sit-Stand Desk • 1900 • INSTRUCTIONS
C
B
E
H
D
D
H
H
F
E
C
C
C
Organize your parts. You will need a phillips screwdriver.
Figure 1
/
