S PEC F ILE
ET-PKC200W
Wall-hanging bracket
As of April 2013
SFD12A018-1
1/2
Specifications
Vertical correction angle: +4° – -2°
Horizontal slant correction angle: +5° – -5°
Dimensions (W × H × D): 463 × 244 × 711 mm
(18-7/32 × 7-27/32 × 28 inches)
Weight: Approx. 8.5 kg* (18.7 lbs*)
Applicable projector:PT-CW331R/CW330/CW241R/CW240/CX301R/CX300
Parts Wall-hanging bracket . . . . . . . . . . . . . . . . . . . . .1
Washer-fitted screws (M4 × 10) . . . . . . . . . . . . . . . .9
Projector mounting bracket (L) . . . . . . . . . . . . . . .1
Projector mounting bracket (R) . . . . . . . . . . . . . . .1
Cover plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Arm bracket with adjustment unit . . . . . . . . . . . . .1
Safety wire . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Cable tie . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Wall-hanging bracket mounting sheet . . . . . . . . .1
*
Average value. May differ depending on models.
Description
This bracket is used when mounting a Panasonic’s applicable projector to walls.
Caution:
• Mounting should be done by a qualified technician.
• Make sure that the mounting (wall) area has sufficient strength.
• Read the enclosed mounting instructions thoroughly before starting.
• Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque
wrench and tighten screws to the torque specified in the instructions.
• When the product is no longer going to be used, have it disposed of quickly by a professional disposal service.
357 (14-1/16)
37 (1-15/32)
Maximum length: 834 ( 32-27/32)
549 (21-5/8)
367 (14-7/16)
174
(6-27/32)
475 (18-11/16)
463 (18-7/32)
231
(9-3/32)
70
(2-3/4)
Minimum length:
711 (28)
711 (28)
Projector
Projector
Wall-hanging bracket
Wall-hanging bracket
The illustration shows the wall-hanging bracket
attached to the projector.
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
Washer-fitted hexagonal bolts (M8 × 20) . . . . . . .4
Washer-fitted hexagonal bolts (M5 × 10) . . . . . . .2
S PEC F ILE
ET-PKC200W
Wall-hanging bracket
2/2
Weights and dimensions shown are approximate.
Specifications and appearance are subject to change without notice.
224 (8-13/16)
406 (15-31/32)
463 (18-7/32)
135 (5-5/16)
174 (6-27/32)
27
(1-1/16)
13 × 33
(1/2
× 1-5/16)
45
× 80
(1-25/32
× 3-5/32)
• Wall-hanging bracket
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
As of April 2013
SFD12A018-1
/
