2. BLOTZ
  3. B10-ME-200

BLOTZ B10-ME-200 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the BLOTZ City Wall model B10-ME-200. This document guides you through the construction process using wooden parts and adhesive, detailing each step from basic component assembly to the final decorative finish. I'm ready to help answer your questions about building this model.
  • What type of glue is recommended?
    What tool is required to remove sections from the sprue?
    Is any special care needed when using a knife?
10mm Ancient City Wall - Long
B10-ME-200
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the pieces shown above from the sprue.
Glue them together as shown.
Attach them to the back of the rear wall section.
Glue the sub-assembly to the base.
Add the walkway.
The front wall pieces and strip.
Glue the front wall pieces to the model.
Then add the decorative strip.
The completed building.
/