BLOTZ B28-ME-107 Assembly Instructions

  • Hello! I've reviewed the instructions for the 28mm Desert Fort Long Wall - Arches model. This document provides step-by-step assembly instructions including how to remove pieces, apply glue , attach support, add connectors and front wall. I'm ready to answer any questions you have regarding the construction of the model.
  • What type of glue is recommended?
    What tool is needed to remove sections from the sprue?
    What can be used to hold pieces in place while the glue dries?
28mm Desert Fort Long Wall - Arches
B28-ME-107
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Attach the support pieces to the back of the arch
section.
Glue this assembly to the base and add the
connector pieces (see pic).
Add the walkway gently inserting each lug into the
corresponding hole.
Attach the front wall.
The finished model.
1/1