2. BLOTZ
  3. B20_ME_106

BLOTZ B20_ME_106, B20-ME-106, BH0-ME-106 Assembly Instructions

  • I've reviewed the instructions for the Desert Fort Internal Corner Wall model. This document provides step-by-step guidance on assembling the 20mm scale fort structure, including removal from the sprue, attaching walls and base, and optional door placement. I'm ready to answer your questions about the assembly process.
  • What type of glue is needed?
    What tools are needed for assembly?
    Is the door necessary?
20mm Desert Fort – Internal Corner Wall
B20-ME-106
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
[Optional] Glue the door behind the doorway.
Take the two front wall sections.
Attach these to the model.
Turn the model the right way up and attach the
base, slotting each lug into the associated hole.
The finished model.
/