BLOTZ B10-CS-100 Assembly Instructions

Type
Assembly Instructions

This manual is also suitable for

10mm Car Park
B10-CS-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Lower Level
Start by removing the sections shown above from
the sprue.
Glue the entrance and side wall into position using the
holes/lugs provided.
Then glue the rear wall and other side into place.
Leave to dry.
Upper Level
Each of the four pillars are formed by the two
pieces shown on the left. Slide them together to
form a cross as shown on the right.
Glue each pillar into position using the lugs/holes
provided.
Take the ramp side and insert it (as shown) so
that the floor fits into the slot. It will then be
possible to move the piece fully into position.
Add the end wall and ramp.
Then glue the outer wall into position as shown.
Repeat this for the ramp at the other end of the
level.
Finally glue the two long walls into place.
The completed car park
  • Page 1 1
  • Page 2 2

BLOTZ B10-CS-100 Assembly Instructions

Type
Assembly Instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI