2. KLUS
  3. K-10-WL
K-10-WL

KLUS K-10-WL Operating instructions

  • Hello! I'm your chat assistant, and I've reviewed the mounting instructions for the K-10-WL Fasteners. This document outlines how to install the fasteners with wires and wall mounts for lighting fixtures. It also provides key information about power supply requirements and recommended fastener usage. I'm ready to help answer your questions about this installation process.
  • What is the recommended number of fasteners for a 1-meter fixture?
    What voltage power supply is required?
    Where can more mounting procedures and accessories be found?
*The full range of accessories and electronics is available at www.KlusDesign.eu
www.KlusDesign.eu
NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at www.KlusDesign.eu.
Drawings of extrusions and accessories in these instructions are simplied and only
approximate the actual shapes.
1
K-10-WL Fastener – mounting instructions
1. K-10-WL Fastener (ref. 42672)
2. Wire*
3. Wall fastener*
4. Power supply (12 V / 24 V)*
5. Lighting xture*
1.
2.
3.
4.
5.
CLICK!
CLICK!
www.KlusDesign.eu 2
K-10-WL Fastener – mounting instructions
Mount the fasteners (1) on the wires (2)
and on the wall fasteners (3).
It is recommended to use:
2 fasteners for 1 m of xture
4 fasteners for 2 m of xture
5 fasteners for 3 m of xture
Connect the lighting xture (5)
to the 12 V / 24 V power supply (4)
and snap it in the fasteners.
I
II
5.
1.
2.
3.
4.
1.
2.
3.
/