2. BLOTZ
  3. B20-ST-201

BLOTZ B20-ST-201, B20_ST_201, B28-WW2-200 Assembly Instructions

  • Hello! I've reviewed the provided instructions document for the Blotz Pillbox models B28-WW2-200 and B20-ST-201. This document provides step-by-step guidance on assembling the pillbox model using glue, a knife, and sandpaper. The instructions guide you on how to attach walls and a doorway to the roof, making it useful if you purchased one of these models. I'm ready to answer any questions you might have about the assembly process or the model itself.
  • What type of glue is needed?
    What tools are needed for assembly?
    How many pieces are in the kit?
Type 26 Pillbox
B28-WW2-200 / B20-ST-201
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Type 26 Pillbox
Remove the five pieces of the pillbox from the sprue.
Glue the doorway and one wall to the roof section.
It is easiest to do this with the pillbox resting on its
roof (as shown above). All etched detail should face
outwards.
Glue the other two walls into place and when dry turn
the pillbox the right way up.
/