Star Trac Studio 7 Cycle Installation guide

Brand: Star Trac

Model: Studio 7 Cycle

Type: Installation guide

Studio 7 inStallation inStructionS

Needed CompoNeNts

Please make sure all parts are present prior to

assembly. If missing please call 1-800-503-1221.

2x 740-8247 Foot Plate

4x 110-3681 HHM M8x1.25, 30mm Screw

4x 120-3385 Washer, M8 8.5x19x1.2

4x 120-3388 Split-Lock Washer 8.5mm

1x 740-8981 Pop Pin, Studio Bikes

1x 740-8267-002 Multi-Wrench

1x 740-8267-001 Hex Screw Driver

1x 290-0135 5mm Hex Wrench

1. INstall rear stabIlIzer

Slide the Foot Plate 740-8247 onto frame of bike.

Attach stabilizer 740-9031 using screws 110-3681

(HHM M8x1.25, 30mm Screw) with washer 120-

3385 and split-lock washer 120-3388.

Stabilize bike when it is standing on edge

740-8247

120-3385 (x2)

120-3388 (x2)

110-3681 (x2)

740-9031

2. INstall froNt stabIlIzer

Slide the Foot Plate 740-8247 onto frame of bike.

Attach stabilizer 740-9030 using screws 110-3681

(HHM M8x1.25, 30mm Screw) with washer 120-

3385 and lock ring 120-3388.

740-8247

120-3385 (x2)

120-3388 (x2)

110-3681 (x2)

740-9030

3. INstall seat post base

Make sure plastic sleeve is in frame, then slide seat

post 740-9026 into sleeve, install pop pin 740-8981

and tighten

740-9026

740-8981

4. INstall seat

Pull down on small pin behind the handle to allow

you to slide seat assembly 740-8974 onto seat post

and then tighten with handle 740-8949

740-8974

5. INstall haNdlebar post

Make sure plastic sleeve is in frame, then slide han-

dlebar post 740-8962 into sleeve and tighten with pin

740-8981 (preinstalled)

740-8962

740-8981

740-8967

740-8262

6. INstall haNdlebar

Slide handlebar assembly 740-8967 onto post 740-

8962 such that you can then tighten stop screw 740-

8262 fully. Then tighten handlebar.

7. INstall pedals

Slide pedal taper end into crank (740-7613 R/740-

7614 L) then using a rubber mallet, tap the pedal into

the crank and secure on the inside with bolt 740-

8145 (M8X1.0X22, FLANGE)

740-7613

740-7614

740-8145

8. INstallatIoN Is Complete

For installation assistance or missing parts, please call Startrac Support at 1-800-503-1221

Document #620-8363 - Revision A

Star Trac Studio 7 Cycle Installation guide

Star Trac Studio 7 Cycle Installation guide

Star Trac Studio 7 Cycle Installation guide

Related papers

Other documents