Studio 5 inStallation inStructionS
Needed CompoNeNts
Please make sure all parts are present prior to as-
sembly. If missing please call 1-800-503-1221.
4x 730-0902 Washer, plain, M10, SS
4x 740-7587 Screw. M10x1.5x20mm, HHM
4x 730-0907 Washer, M10, Split lock
1x 740-8981 Pop Pin, Studio Bikes
1x 740-8267-002 Multi-Wrench
1x 740-8267-001 Hex Screw Driver
1x 290-0135 5mm Hex Wrench
4. INstall seat
Pull down on small pin behind the handle to allow
you to slide seat assembly 740-8973 onto seat post
and then tighten with handle 740-8949
5. INstall haNdlebar post
Make sure plastic sleeve is in frame, then slide han-
dlebar post 740-8963 into sleeve and tighten with pin
740-8981 (preinstalled)
6. INstall haNdlebar
Slide handlebar assembly 740-8966 onto post
740-8963 such that you can then tighten stop screw
740-8177 fully. Then tighten handlebar.
7. INstall pedals
Slide pedal taper end into crank (740-7613 R/740-
7614 L) then using a rubber mallet, tap the pedal into
the crank and secure on the inside with bolt 740-
8145 (M8X1.0X22, FLANGE)
8. INstallatIoN Is Complete
For installation assistance or missing parts, please call Startrac Support at 1-800-503-1221
Document #620-8362 - Revision A
1. INstall rear stabIlIzer
Place bike frame on end and attach stabilizer 740-
8976-XX using screws 740-7587 (Screw. M10x-
1.5x20mm, HHM) with washer 730-0902 and split-
lock washer 730-0907.
Stabilize bike when it is standing on edge
2. INstall froNt stabIlIzer
Attach stabilizer 740-8977-XX using screws 740-
7587 (Screw. M10x1.5x20mm, HHM) with washer
730-0902 and split-lock washer 730-0907.
3. INstall seat post base
Make sure plastic sleeve is in frame, then slide seat
post 740-8971 into sleeve, install pop pin 740-8981
and tighten
/
