Studio 3 inStallation inStructionS
Needed CompoNeNts
Please make sure all parts are present prior to
assembly. If missing please call 1-800-503-1221.
4x 110-3687 BHC Screw, M8X1.25, 45mm
8x 120-3390 Washer, M8, 8.5x19x1.2mm
4x 110-3672 Nut, M8 X 1.25
1x 740-8267-002 Multi-Wrench
1x 740-8267-001 Hex Screw Driver
1x 290-0135 5mm Hex Wrench
For installation assistance or missing parts, please call Startrac Support at 1-800-503-1221
1. INstall rear stabIlIzer
Place bike on stabilizers 003-7555 and 740-8744 with transport wheels
on front. Attach stabilizers using screws 110-3681 (Screw, M8X1.25,
45mm) with washer 120-3390 above and below stabilizer, tighten into
nut 110-3672.
While tightening nuts, if you upend the bike, be sure to stabilize it
if standing on edge
2. INstall seat post
Loosen pop pin 740-9029 then slide seat post 740-8995 into frame.
Tighten pop pin at desired height.
3. INstall haNdlebar
Loosen pop pin 740-9029 then slide handlebar 740-8746 into frame.
Tighten pop pin at desired height.
4. INstall pedals
Use multi-wrench in hardware card or appropriate wrench to screw in
pedals (003-7599 R/003-7605 L), tighten till secure.
5. INstallatIoN Is Complete
Document #620-8361 - Revision A
/
