USE OF THE SELECTION CONTROLS
D
. SPIN EXCLUSION BUTTON
This button excludes the spin cycle from the wash programme. This option is
recommended for special fabrics.
E
. FLOT BUTTON (Anticreasing)
The Flot button only works in programmes (4-5-6-7-8) for mixed, synthetic
and very delicate fabrics.
When the button is pressed, the machine stops in the last rinse of these
programmes, leaving the wash soaking with a high water level.
To complete these programmes, spin the wash by pressing the button again to
release it.
G
. ON/OFF PILOT LIGHT
H
. ON/OFF BUTTON
USE OF THE SELECTION CONTROLS
A
. PROGRAMME SELECTOR KNOB
With this knob you can select the wash programme as you
wish. Press the central knob and then pull out and turn until
the programme (number or symbol) coincides with the marker
point. Having made the selection, press the knob in again.
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button
(H) before selecting the programme
.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the Start/Stop key. Press again to recommence once the
modification has been completed.
B
. TEMPERATURE SELECTOR KNOB
With this knob you can select the washing temperature as
you wish. Press the central knob and then pull out and turn
until the temperature selected coincides with the marker point.
Having made the selection, press the knob in again.
If you wish to carry out a cold wash, turn the knob until the
cold symbol coincides with the selector mark.
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
Do not exceed the maximum temperature recommended for
each cycle in the table of programmes.
11
12
T
C