Toro KIT-BUMPER, REAR [HDX] User manual

Brand: Toro

Model: KIT-BUMPER, REAR [HDX]

Type: User manual

 NOTE: Read these installation instructions thoroughly before beginning the installation process. Retain

these Installation Instructions for future reference.

Arctic Cat

Prowler

Installation Instructions - Accessory Kit

Form No. 0453-718

HDX Rear Bumper Kit

(p/n 1436-609)

Application: Prowler HDX

Kit includes:

p/n QTY DESCRIPTION

N/A 1 Rear Bumper

0423-771 2 Plastic Cap (44.4 mm OD x 40.2 mm ID)

* 2 Rivnut

* 2 Nyloc Hex Nut

* 2 Flange Button-Head Screw

* 2 Fender Washer

* 2 Hex Nut (8 mm)

* 2 Large Flat Washer

* 4 Small Flat Washer

* 2 Machine Screw

0453-718 1 Instruction

*Included in Hardware Kit (1541-401)

1. Remove the two rear carriage bolts and hex nuts

securing the cargo box assembly to the box frame.

Discard the carriage bolts and hex nuts.

 NOTE: In order to complete the remaining steps

for this kit, it will be necessary to have the help of

an assistant.

2. From inside the cargo box insert two new flange

button-head screws (A) through two large fender

washers (B) and the mounting holes in the cargo

box. Install large flat washer (C) and hex nuts (D)

to the underside of the cargo box and secure. With

the help of an assistant, position rear bumper

under the cargo box with the mounting holes

aligned with the inserted carriage bolts. Secure the

bumper with small flat washers (G) and nyloc hex

nuts (H).

3. Make sure the bumper is flush with the bottom of

the cargo box frame; then using the bumper as a

template, mark the two front mounting holes in the

frame using a center punch. Remove the bumper.

4. Using a 25/64-drill bit, drill out the two holes in

the frame.

5. Install Rivnut (E) into each of the two mounting

holes drilled from step 4.

 NOTE: It is advisable to use Rivnut Tool (p/n

0644-232) to make the installation of the rear bum-

per easier.

6. Position the bumper under the frame; then loosely

secure the rear section of the bumper using the car-

riage bolts, small flat washers, and nyloc hex nuts.

7. Secure the front section of the bumper using two

small flat washers and two machine screws (I).

Securely tighten the front machine screws; then

securely tighten the rear carriage bolts.

8. Install plastic cap (F) into each end of the bumper.

See Fig. 1.

Fig. 1

UTV-112A

Printed in the U.S.A. ®™Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 0315

Toro KIT-BUMPER, REAR [HDX] User manual

Toro KIT-BUMPER, REAR [HDX] User manual

Toro KIT-BUMPER, REAR [HDX] User manual

Related papers

Other documents