Toro KIT-FULL WINDSHIELD, PROWLER (RP) User manual

Hello! I am an AI chatbot trained to assist you with the Toro KIT-FULL WINDSHIELD, PROWLER (RP) User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

 NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain

these Installation Instructions for future reference.

Arctic Cat

Prowler

Installation Instructions - Accessory Kit

Form No. 0453-691

Full Windshield Kit

(p/n 1436-829 & 1436-515)

Kit includes:

Ref. No. p./n QTY DESCRIPTION

1 N/A 1 Windshield

2 2441-224 8 Rubber Clamp

3 * 8 Machine Screw

4 * 8 Flat Washer

5 * 8 Nut

6 * 1 Adhesive Foam

0453-691 1 Instructions

* Included in Hardware Kit (p/n 1436-573)

1. Thoroughly clean the installation area on the vehi-

cle.

2. Apply Adhesive Foam (6) along the inside perime-

ter of the Windshield (1); then align windshield

with the hood and front ROPS bars. See Fig. 1.

Fig. 1

UTV-095A

3. Place eight Rubber Clamps (2) on the forward-

most section of the ROPS making sure the flat side

of the clamp is facing toward the front of the vehi-

cle.

4. Secure the windshield to the ROPS using eight

Machine Screws (3), eight Flat Washers (4), and

eight Nuts (5). Tighten until snug only.

CAUTION

Do not over-tighten the nuts. Damage to the wind-

shield may occur.

Printed in the U.S.A. ®™Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 1013