NCR 7403-K171 Instructions Manual

NCR
Brand
NCR
Model
7403-K171
Type
Instructions Manual
7403-K171
Integrated CD/DVD ROM
Kit Instructions
Issue A
Revision Record
Issue
Date
Remarks
A
Nov 2008
First issue
1
Introduction
This kit adds an Integrated CD/DVD-ROM Drive to the 7403.
2
Installation Procedures
Caution: Static Electricity Discharge may permanently damage your system.
Discharge any static electricity build up in your body by touching your computer’s
case for a few seconds. Avoid any contact with internal parts and handle cards only
by their external edges.
1. Disconnect power to the terminal.
Caution: Disconnect the AC power cord before disassembling the terminal. The
ON/OFF switch does NOT remove power to the unit.
a. Remove the Front Cover.
b. Insert the Security Key and turn it 90 degrees clockwise.
26124
Security Key
Front Base Cover
3
c. Pivot the top of the Front Base Cover toward the front of the unit and remove
it from the terminal.
26032
d. Disconnect the Power Cord from the Power Supply.
26135
AC Power Cord
4
2. Remove the Cable Clamp. This clamp is not used when the DVD is present.
Loosen the thumbscrew and remove the screw on the opposite end of the clamp.
26461
Cable Clamp
3. Carefully position the terminal on its back.
4. Remove the No DVD Cover (1 screw).
26463
No DVD Cover
5
5. Connect the CD/DVD Power and SATA Cables to the DVD Drive.
6. Secure the cables to the CD/DVD Bracket using a tie wrap.
7. Fold the cables as shown below. Route the Power Cable as shown to keep it out
from under the sheet metal when installing the drive.
26459
CD/DVD Power Cable
CD/DVD SATA Cable
CD/DVD Drive
6
8. Connect the CD/DVD Power and SATA Cables to the 7403 Backplane Board.
9. Install the CD/DVD Assembly.
a. Align the tabs (4) on the edge of the DVD Bracket above the slots in the 7403
Base.
b. Slide the DVD Bracket down into the slots.
7
10. Secure the assembly with the DVD Bracket Thumbscrew.
26147a
DVD Bracket Thumbscrew
Pivoting Extensions
Cable Tie Wrap Anchor Points
11. Route the external cables in the channel(s) and pivot the extensions to keep the
cables secure. Secure the cables to the Base using Tie Wraps as necessary.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11

NCR 7403-K171 Instructions Manual

NCR
Brand
NCR
Model
7403-K171
Type
Instructions Manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents