Legrand LightSaver® Dimming Wall Switch (LS-4 ) Installation guide

Brand: Legrand

Model: LightSaver® Dimming Wall Switch (LS-4 )

Type: Installation guide

Operation

The LS-4 has 4 buttons and an LED indicator.

Automatic LED indicator

When the LED indicator is on, the controller is automatically dimming the lights.

If the LED is off, the LCD controller is operating in the manual mode.

Automatic button

The upper left button switches the controller into automatic operation. Note that

if the controller is already in automatic pressing this button does nothing.

Off button

Pressing the upper right button dims the lights to a 0 VDC signal.

On button

Pressing the button at the bottom left corner sets the output signal to its full

output. Note, continuing to press this button will cause the lights to dim.

Dimming button

The ﬁrst time that the button at the bottom right corner is pressed, the output

signal increases to the maximum level. Continuing to press the button will

cause the signal to move through the dimming cycle, initially dimming the

lights to the minimum and then beginning to increase the light level. When the

button is released, the signal will stay at the light level present when the button

was last pressed. If the button is pressed again within 30 seconds, it will con-

tinue to cycle as if it had been continuously pressed. After 30 seconds of inac-

tivity, pressing the button will cause the LCD controller to re-initiate the dim-

ming cycle.

Wiring

Use 18AWG 5 conductor cable to connect the switch to the LCD controller. Use

Belden 8465 or equal.

The maximum wire length from the control module is 150 feet.

Note: Low voltage wiring must be isolated from the line voltage wiring.

The LS-4 is supplied with color coded wire leads. Please follow the wiring dia-

gram, below, to make wiring connections.

45 78123

LCD-103

5-conductor cable

equal to Belden 8465

Autom.

Brown

Green

Red

White

Black

Technical Support:

1(800)879-8585 1(972)578-1699 xxxxxr2 10/00

LS-4 Dimming Control

Low Voltage Wall Switch

Speciﬁcation

Supply Voltage . . . . . . . . . . . . . . . . . . 5 VDC

Description

The LS-4 is a dimming control low voltage

wall switch designed to work with the LCD

series of dimming controllers. The LS-4 pro-

vides the ability to override the LCD con-

troller for manual light level adjustment.

Autom.

utom

All information in this drawing is the property of The Watt Stopper Inc. and

cannot be copied or used without the written approval of The Watt Stopper Inc.

Installation Instructions

Technical Support:

1(800)879-8585 1(972)578-1699 xxxxxr1 8/00

Drawn by: HUCKABONE

PLM:

Project Engr:

MarComm Dir:

Sheet: 1 of 1 Scale: 1 : 1

the Watt Stopper Inc.

SANTA CLARA, CALIFORNIA

Title:

LS-150 Photocell series Installation Instructions

Drawing #: Original Drwg. Date: 15 AUG 00 Rev #:

xxxxx Rev. Date: 15 AUG 00 d2

MATERIAL: Paper, white, glossy

80# Book

FLAT (cut) SIZE: 5" W x 7" H

FOLDING: Quarter fold

INK COLOR: Black

REV. DESCRIPTION INT: REV. DATE APPROVED

1 ECO#xxxxxxxx

DRAFT

Legrand LightSaver® Dimming Wall Switch (LS-4 ) Installation guide

Legrand LightSaver® Dimming Wall Switch (LS-4 ) Installation guide

Legrand LightSaver® Dimming Wall Switch (LS-4 ) Installation guide

Related papers

Other documents