2. BLOTZ
  3. B28-SFC-002

BLOTZ B28-SFC-002 Assembly Instructions

  • I have analyzed the instruction manual for the BLOTZ Walkway Set B28-SFC-002. This document provides step-by-step guidance on assembling the 28mm scale model walkways, including gluing the floor pieces, attaching the uprights, and adding the handrails. I am ready to answer your questions about the assembly process or the set's features.
  • What kind of glue do I need?
    Can I use sandpaper?
    What tool is needed to remove parts from the sprue?
28mm Walkway Set #1
B28-SFC-002
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Each walkway “floor” is made from two pieces as
shown above.
Turn the top piece over and glue the “base”
underneath it, ensuring the notches line up.
Take the uprights.
Clip them to the walkway.
Add the handrails – making sure they flare outwards at each end (see pic)
The completed walkways.
/