2. BLOTZ
  3. B28-SFC-007

BLOTZ B28-SFC-007 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Walkway B28-SFC-007. This document provides a step-by-step guide for assembling the 28mm 'T' Walkway model. It details how to use glue, sandpaper, and a modelling knife, and explains how to attach the various parts like the base, floor, and handrail to complete the model. I am ready to assist with any questions you might have about its assembly.
  • What kind of glue is needed for assembly?
    What tools are required for assembly?
    Can I use clamps to hold pieces together while assembling?
28mm “T” Walkway
B28-SFC-007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Each walkway “floor” is made from three pieces as
shown above.
Turn the top pieces over and glue the “base”
underneath them, ensuring the notches line up.
Take the uprights.
Clip them to the walkway.
Add the handrail, ensuring it flares outward at
each end.
Select either the long or short leg pieces.
Attach the foot.
Glue the leg into position.
The finished walkway.
/