2. BLOTZ
  3. B15-ME-212

BLOTZ B15-ME-212 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the City Wall End Caps model. The document details the steps for construction, including attaching connectors, the base, walkway, and other components. I am ready to assist with your questions about the assembly process.
  • What type of glue is needed to assemble the model?
    What tools are needed for assembly?
    What should I do while the glue dries?
15mm Ancient City Walls – Wall End Caps
B15-ME-212
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue the connectors to the main support and attach
the rear wall.
Add the base.
Attach the walkway.
Add the side plate.
Glue the two sections of front wall to the model.
Add the strip.
Remove the pieces shown above from the sprue.
Glue the connectors to the main support and add
the rear wall.
Add the base.
Attach the walkway.
Add the side plate.
Glue the two sections of front wall to the model.
Add the strip.
The finished models.
The models once painted.
/