BLOTZ B28-ME-212 Assembly Instructions

28mm Ancient City Walls – Damaged Wall

B28-ME-212

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care

and remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in

place while you allow glue to dry.

There are 2 sheets marked “A” and two marked “B”. The two marked “A” make one wall piece, while “B”

contains the parts for the other wall piece.

Remove the pieces shown above from the sprue.

Glue the connectors to the main supports, then

attach the rear wall.

Glue the whole assembly to the base and add the

walkway.

Take the end braces.

Glue them to the model (see pic).

Each layer of bricks is made up of two pieces. One

with etched details and one which is blank.

This shows the first four layers (in order).

Glue them to the model.

Add the front wall pieces and strip.

The final three layers.

Glue these into place.

Repeat this process for the other wall section.

The finished model.

Download PDF