2. BLOTZ
  3. B28-SF-231

BLOTZ B28-SF-231 Assembly Instructions

  • Hello! I've reviewed the instructions for the 28mm Walkway - Front Wedge, model B28-SF-231. This document details how to assemble the model using glue, a sharp knife and sandpaper. I'm familiar with the steps for assembling the support column, feet, base, barricade sections and armour plates and I'm ready to answer your questions about this model.
  • What type of glue is needed for assembly?
    What tool is needed to remove parts from the sprue?
    Is sandpaper usefull during assembly?
28mm Walkway – Front Wedge
B28-SF-231
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the two pieces of the support column and the
four feet as shown above from the sprue.
Glue the support column together, then attach the
feet (see pic).
Glue the support column to the base.
Take the two pieces shown above from the sprue.
Glue the one on the right to the back of the one on the
left.
Take the barricade sections…
..and glue them into position (see pic).
Glue the walkway into place.
Glue the two assemblies together.
Take the armour plates.
Glue them into position.
The finished model.
/