Caution : You must read this before you proceed.
BISTRO CHAIR
CAUTION : This chair is NOT a TOY.
Keep your child / children at bay in the process of assembly.
Assembly Instructions
1 OF 4
NO. Picture QTY
D 2
E 2
F 8
22
22
22
K 1
Washers(8mm)
Parts list
Description
Chair seat
Chair leg with pre-attached Leveller
Backrest
Assembly Preparation
Before Beginning Assembly:
Nut(8mm)
Spring washers(8mm)
Spanner
Hard ware
H
2 OF 4
Turn the chair right side up.
Adjust the Legs with pre-installed Levellers, until the chair is level with the
ground.
Tighten all screws and bolts.
Upon completion of full assembly and bolted up-all screws can be
tightened down.
Your chair is now ready for use.
Unpack and place all parts on a clean soft surface.
Align the two studs on the Backrest(D )with the holes in the Chair Seat(E).
Then attach the Backrest(D) to the the Chair Seat(E)by using Washers,Spring
washers, Nuts(H) .
Tighten the Nut using the Spanner(K).
DO NOT OVERTIGHTEN.
Attach the Chair legs(F)to the studs on the Chair Seat(E)by using
Washers,Spring washers and Nuts(H).Tighten the Nuts using the Spanner(K).
DO NOT OVERTIGHTEN.
Assembly Step
3 OF 4
4 OF 4
/
