Assembly instructions
TAHOE CAST BENCH
1 of 5
CAUTION : This chair is NOT a TOY.
Keep your child / children at bay in the process of assembly.
1 of 5
Assembly Preparation
Before Beginning Assembly:
2 of 5
NO. Picture QTY
A1
B1
C1
D1
Left Arm with Pre-attached Leg
Levellers.
Chair Seat Panel
Right Arm with Pre-attached Leg
Levellers
Parts list
Description
Backrest Panel
2 of 5
E5
5
5
5
G5
5
5
5
F
H
Bolts(6*30mm)
Washers(6mm)
Spring Washers(6mm)
Nuts(6mm)
Nuts(8mm)
Hard ware
Bolts(8*32mm)
Washers(8mm)
Spring Washers(8mm)
3 of 5
5
I2
Unpack and place all parts on a clean soft surface.
Nut Caps(M6)
Spanner
Assembly Step
3 of 5
Align the mounting positions on the Chair Seat Panel (B) with the mounting
positions on the Right Arm (C) .
Insert the bolts from the mounting positions on the Right Arm (C) to the mounting
positions on Chair Seat Panel (B)
Put Flat washers+ Spring washers + Nuts(F) to the Blots(E), partially tighten all
bolts into position.
E
I
F
I
G
H
B
C
A
Turn the Chair rightside. Adjust the pre-installed Rubber Caps until the chair is
level with the ground , tighten all screws and bolts. Your Chair is ready for use.
Once all Bolts and Nuts are in postion, use one Spanner (I) to hold the Bolt, and
the other Spanner to turn lock the Nut.
Repeat the same steps to attach Backrest Panel(A) to Right Arm (C)
Put on the Nut caps(H) after lock the Nut.
DO NOT OVERTIGHTEN.
Repeat the same steps for the Left part.
4 of 5
5 OF 55 OF 5
/
