2. BLOTZ
  3. B20_ACC_003

BLOTZ B20_ACC_003, B20-ACC-003 Assembly Instructions

  • Hello, I'm your chat assistant. I've reviewed the provided instructions for the BLOTZ Billboard B20-ACC-003 assembly. This document details how to construct three 20mm scale billboards, using common tools and materials like PVA glue, sandpaper, and a modeling knife. I'm ready to assist you with any questions you have regarding the assembly process.
  • What kind of glue is needed?
    What tool is recommended for joint cleaning?
    What tool is needed to remove parts from the sprue?
    What can be used to hold pieces together while the glue dries?
20mm Billboards
B20-ACC-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Two of the billboards are formed using the pieces
shown above.
Simply insert the lugs on the billboard into the base as
shown.
The third billboard uses these pieces.
First of all insert the supports into the back of the
billboard (i.e. the side without the etches rectangle on
it)
Then insert the supports into the base. Note the
supports should be aligned so that they touch
one edge of the base (see pic)
/