2. BLOTZ
  3. B15-ME-003

BLOTZ B15-ME-003 Assembly Instructions

  • I've reviewed the user manual for the BLOTZ Middle Eastern B15-MW-003 building model. This document provides step-by-step instructions on how to assemble the 15mm scale model, including details on gluing, roof supports, and the optional trapdoor. I'm ready to answer any questions you have about constructing this model.
  • What kind of glue is required?
    What tool is needed to remove parts from the sprue?
    Can I glue the roof?
    What scale is the building?
15mm Middle Eastern Building #3
B15-MW-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Middle Eastern Building #3 (B15-MW-003)
For each section of the building, remove it from the
sprue along with the relevant number of roof
supports.
Glue the supports to the back of the section.
All the sections with their roof supports attached.
Glue the door section to the two long outer walls as
shown above.
Attach the rear wall and gateway sections.
Add the roof (do not glue).
If required add the trapdoor.
The finished building.
/