Legrand KSU Interface Kit - Panasonic KXTA624, IS-0015 Installation guide

Legrand
Brand
Legrand
Model
KSU Interface Kit - Panasonic KXTA624, IS-0015
Type
Installation guide

This manual is also suitable for

Legrand KSU Interface Kit - Panasonic KXTA624, IS-0015

The Legrand KSU Interface Kit is designed to connect the OnQ 1x11 KSWPBX T&corn Module to KSU systems, such as the Panasonic KXT30810. It consists of two cable assemblies: one connects the incoming lines from the service provider to the KSU, and the second connects the extensions from the KSU to the individual outlet cable.

The KSU Interface Kit supports up to four incoming lines and eleven two-pair extensions. If you need more incoming lines or extensions, you can use two kits and an additional telecom module.

The hydra cable has an RJ45 connector on one end and 4 RJ11 connectors on the other. The second cable has a 50-position Champ connector on one end and 11 RJ11 connectors on the other.

Legrand KSU Interface Kit - Panasonic KXTA624, IS-0015

The Legrand KSU Interface Kit is designed to connect the OnQ 1x11 KSWPBX T&corn Module to KSU systems, such as the Panasonic KXT30810. It consists of two cable assemblies: one connects the incoming lines from the service provider to the KSU, and the second connects the extensions from the KSU to the individual outlet cable.

The KSU Interface Kit supports up to four incoming lines and eleven two-pair extensions. If you need more incoming lines or extensions, you can use two kits and an additional telecom module.

The hydra cable has an RJ45 connector on one end and 4 RJ11 connectors on the other. The second cable has a 50-position Champ connector on one end and 11 RJ11 connectors on the other.

Instruction/Installation Sheet
OnQ KSU Interface Kit
1. Introduction:
Figure 1
The OnQ KSU Interface Kit, palt number 363490-01, connects the OnQ 1x11 KSWPBX T&corn Module (P/N
363485-011 with KSWPBX svstems. such as the Panasonic KXT30810. The kit consists of two cable
assemblies. One connects &e in&ming lines from the service provider to the KSU, the second connects the
extensions from the KSU to the individual outlet cable.
The KSU Intelface Kit can support up to four incoming lines and eleven two-pair extensions. For systems
requiring additional incoming lines and/or extensions two kits and an additional telecom module will be required.
2. Description:
The OnQ KSU Interface Kit consist of two cable assemblies. The hydra cable has an RJ45 connector on one
end and 4 RJll connectors on the other. The cable is a 4 pair cable with all four pair terminated in the RJ45
and one pair in each of the RJI 1 connectors marked 1 to 4:
The second cable has 50 position Champ connector on one end and 11 RJI 1 connectors on the other end. The
cable is 25 pair Cat 3 cable. Twenty-two pairs are terminated in the Champ connector. Two pair are terminated
in each of the RJll connectors marked 1 to II.
This product is listed to UL 1863 - Communications Circuit Accessories
This product complies with General Approval NS/G/1235/W/100025
3. Installation
The KSU Interface Kit is designed to be used with the OnQ 1x11 KSU/PBX Telecom Module, part
number 363465-01. These installation instructions assume the module has been properly installed
along with the KSU.
A. Route the two cable assemblies between the Telecom Module and the KSU. The ends with the RJll
connectors go to the KSU and the champ end and RJ45 end go to the module.
B. Plug the RJ45 into either of the ‘“Line Jack” connectors on the t&corn modules.
C. Remove !I& of commoning boards from the two Champ connectors on the t&corn module.
D. Connect the Champ connector from the cable assembly to the top Champ, marked “Line l&2”.
E. At the KSU connect up to 4 incoming lines from the hydra cable to the line in of the KSU.
IS- 0015 Rev. B
Page 1 of 2
r-------
/
/
/ ‘Imp “D!‘“‘>X~
/
au!’ a’was I
;:
$1
I
$1
>’
E’
I
  • Page 1 1
  • Page 2 2

Legrand KSU Interface Kit - Panasonic KXTA624, IS-0015 Installation guide

Legrand
Brand
Legrand
Model
KSU Interface Kit - Panasonic KXTA624, IS-0015
Type
Installation guide
This manual is also suitable for

Legrand KSU Interface Kit - Panasonic KXTA624, IS-0015

The Legrand KSU Interface Kit is designed to connect the OnQ 1x11 KSWPBX T&corn Module to KSU systems, such as the Panasonic KXT30810. It consists of two cable assemblies: one connects the incoming lines from the service provider to the KSU, and the second connects the extensions from the KSU to the individual outlet cable.

The KSU Interface Kit supports up to four incoming lines and eleven two-pair extensions. If you need more incoming lines or extensions, you can use two kits and an additional telecom module.

The hydra cable has an RJ45 connector on one end and 4 RJ11 connectors on the other. The second cable has a 50-position Champ connector on one end and 11 RJ11 connectors on the other.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents