Legrand Telecom Surge Suppression Unit - 363487-01 Installation guide

Brand: Legrand

Model: Telecom Surge Suppression Unit - 363487-01

Type: Installation guide

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 1

INSTRUCTION/INSTALLATION SHEET

Telecom Surge Suppression Unit

IS-0016 REV. D

1. Introduction

The On-Q/Legrand Telecom Surge Suppression Unit, P/N 363487-01, (see

Figure 1) provides supplemental protection for telecommunications

equipment from high voltage surges. It is designed to work with On-Q

Telecom Modules such as the P/N 1267062-01 (1x6 Basic Telecom Module),

P/N 364551-01 (1x8 Enhanced Telecom Module) and P/N 363485-01 (1x11

KSU/PBX Telecom Module), all of which can be directly mounted in any

On-Q style enclosure.

2. Description

The On-Q Telecom Surge Suppression Unit consists of a surge unit and a terminated ground lead. The surge unit

is approximately 1.5” x 1.5” x .75” in size, and the supplied ground lead has a female spade connector terminated

on one end.

NOTE: This product complies with General Approval NS/G/1235/100025.

3. Installation

A. Plug the surge unit into the 20

position interface connector on the

Telecom Module (see Figure 2).

The surge unit has a 24 position

connector with keying plugs

installed to ensure proper

connection onto the 20 position

interface connector. The surge unit

is not sensitive to orientation.

B. Connect the ground lead female

spade lug onto the male spade

connector on the Telecom Module.

C. Route the other end of the ground

cable to the ground lug of the

enclosure. Strip the ground wire and

secure it in the ground lug.

NOTE: Ensure that the enclosure is

properly earth grounded.

Figure 1

Figure 2

Legrand Telecom Surge Suppression Unit - 363487-01 Installation guide

Legrand Telecom Surge Suppression Unit - 363487-01 Installation guide

Legrand Telecom Surge Suppression Unit - 363487-01 Installation guide

Related papers

Other documents