Legrand Telecom Surge Suppression Unit, IS-0016 Installation guide

1. Introduction

The OnQ Telecom Surge Suppression Unit provides supplemental protection for telecommunication equipment

from high voltage surges. The Surge Suppression Unit is designed to work with OnQ Telecom Modules, such as

part numbers 1267062-01 (1x6 Basic), 363940-01 (6 Port Telecom Expansion), 363484-01 (1x11 Telecom) and

363485-01 (1x11 KSU/PBX Telecom), which can be mounted in OnQ Service Center Enclosures.

2. Description

The OnQ Telecom Surge Suppression Unit consists of a surge unit and a terminated ground lead. The Surge

unit is approximately 1.5” x 1.5” x .75” including the printed wiring board and interface connector. The ground

lead has a receptacle contact on one end.

This product compiles with General Approval NS/G/1235/100025

3. Installation

A. Plug surge unit into the 20 position interface connector on the Telecom Module (refer to example in

Figure 1 below).

The surge unit has a 24 position connector with keying plugs installed to ensure proper connection to

the center 20 positions. The unit is not sensitive to orientation.

B. Connect the ground lead receptacle to the ground tab on the Telecom Module.

C. Route the cable to the ground lug of the enclosure. Strip and secure in the ground lug.

NOTE: Make sure that the enclosure is properly earth grounded.

OnQ Technologies, Inc.

P.O. Box 60907

Harrisburg, PA 17106-0907

800-321-2343

www.onqtech.com

Installation/Instruction Sheet

OnQ Telecom Surge Suppression Unit

IS-0016 Rev. C

IS-0016 Rev. C Page 1 of 1

Ref. P/N 363605-16

Figure 1

Shown w/PN 363485-01