Whirlpool AKR 650 GY Program Chart

Category
Cooker hoods
Type
Program Chart

This manual is also suitable for

AKR 950 - AKR 959
5019 318 33091
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 50 cm (Elektrokochplatten), 75 cm (Gas-, Öl- oder
Kohlekochplatten). Folgen Sie bei der Installation der Nummerierung
(1
Ö
2
Ö
3
Ö
.....). Schließen Sie das Gerät erst nach erfolgter Installation an die
Stromversorgung an. Achtung! Das Auslassrohr und die Befestigungsmanschetten
(15) sind nicht im Lieferumfang inbegriffen und müssen gesondert erworben werden.
INSTALLATION SHEET
Minimum height above cooker: 50 cm (electric cookers), 75 cm (gas, gas oil or
coal cookers). To install, follow points (1
Ö
2
Ö
3
Ö
.....). Do not connect the
appliance to the electrical power supply until installation is completed. Warning!
The exhaust pipe and clamps (15) are not supplied and must be bought separately.
FICHE D'INSTALLATION
Distance minimale par rapport à la cuisinière : 50 cm (cuisinière électrique),
75 cm (cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la
numérotation (1
Ö
2
Ö
3
Ö
.....). Ne branchez pas l'appareil tant que l'installation
n'est pas terminée. Attention ! Le conduit d'évacuation et les colliers de fixation
(15) ne sont pas fournis et doivent être achetés à part.
INSTALLATIEKAART
Minimumafstand tot het kooktoestel: 50 cm (elektrische kooktoestellen), 75 cm
(kooktoestellen op gas, olie of kolen). Volg voor de montage de nummering
(1
Ö
2
Ö
3
Ö
.....). Geef het apparaat geen stroom totdat de installatie geheel
voltooid is. Let op de afvoerbuis en de klembanden (15) worden niet bijgeleverd
en moeten apart worden aangeschaft.
FICHA DE INSTALACIÓN
Distancia mínima desde los quemadores: 50 cm (quemadores eléctricos), 75 cm
(quemadores de gas, gasóleo o carbón). Para el montaje, siga la numeración
(1
Ö
2
Ö
3
Ö
...). No conecte el aparato a la corriente eléctrica hasta que la
instalación esté completamente finalizada. ¡Atención! El tubo de descarga y las
abrazaderas (15) no están incluidas y se compran aparte.
FICHA DE INSTALAÇÃO
Distância mínima dos fogões: 50 cm (fogões eléctricos), 75 cm (fogões a gás,
gasóleo ou carbono). Para a montagem siga a numeração (1
Ö
2
Ö
3
Ö
.....). Não
ligue o aparelho à corrente eléctrica até a instalação estar concluída. Atenção! O
tubo de descarga e as tiras de fixação (15) não são fornecidas e devem ser
compradas à parte.
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 50 cm (fuochi elettrici), 75 cm (fuochi a gas,
gasolio o carbone). Per il montaggio seguire la numerazione (1
Ö
2
Ö
3
Ö
.....).
Non dare corrente allapparecchio finché linstallazione non è totalmente
completata. Attenzione! Il tubo di scarico e le fascette di fissaggio (15) non
sono fornite e vanno acquistate a parte.
ùüùü+ùùùþ
ü$12.)12.1.)2"0120" FP02!"0120" FP
0120".0! #02!0. #0! # +.22  21
.  #1202.!1
1
Ö
2
Ö
3
Ö
2! 3 / 20200
02!)!0*.21#10 #!2  !&12"0.212.1"
! 1 $1&."..&".2. !.120!&1"/0
/.202..!0.. 2 *$&!12
D
GB
F
NL
E
P
I
*5
31833091.fm Page 1 Thursday, November 27, 2003 3:45 PM
5019 318 33091
AKR 950 - AKR 959
=
=
X
G
20b
20b
7-16
7-16
4
5
6
8
9
14
14
15
18
20a
20a
9
8
19
8
9
1
17
B
G
H
11
11
1
21
F
2
2
12
13
10
17
1
3
3
3
3
3
31833091.fm Page 2 Thursday, November 27, 2003 3:45 PM
AKR 950 - AKR 959
5019 318 33091
D F NL E
GB
P I GR
Preliminary information for installing the hood:
Disconnect the power supply at the domestic main switch before carrying out electrical connections.
1.
Place the extraction unit on a flat surface and fit the bottom part of the hood on it
(remove the grease filter/s).
2.
Carry out the electrical connections between the two parts.
3.
Fix the hood to the extraction unit with 6 screws.
4.
Using a pencil, draw the centre line on the wall up to the ceiling to facilitate installation operations.
5.
Attach the hole diagram to the wall: the vertical centre line printed on the hole diagram must match the
centre line drawn on the wall, and the lower edge of the hole diagram must match the lower edge of the
hood: remember that with installation completed the bottom of the hood must be at least 50 cm above
the cooktop in case of electric cookers and 75 cm in case of gas or mixed cookers.
6.
Place the support bracket on the hole diagram so that it matches the dashed rectangle, mark the two
external holes and drill, remove the hole diagram, insert 2 wall plugs and fix the hood support bracket
with two 5x45 mm screws.
7.
Hook the hood to the bracket.
8.
Adjust the distance between the hood and the wall.
9.
Adjust the hood horizontally.
10.
From the inside of the hood, mark the holes for fixing it.
11.
Remove the hood from the bracket.
12.
Drill on the mark (Ø 8 mm - see step 10).
13.
Insert 1 wall plug.
14.
Fit the flue support bracket
G
to the wall and against the ceiling, use the support bracket as hole diagram
(the small slot on the support must match the line drawn on the wall - step 4) and mark 2 holes with the
pencil, drill the holes (Ø 8 mm), and finally insert 2 plugs.
15.
Fix the flue support bracket to the wall with two 5x45 mm screws.
16.
Hook the hood to the bottom bracket.
17.
Fix the hood with a 5 x 45 mm screw (ABSOLUTELY NECESSARY).
18.
Connect an exhaust pipe (pipe and clamps are not supplied and must be bought separately) to the collar
B
located above the extraction motor unit.
For extractor operation, connect the other end of the exhaust pipe to the home discharge device. For filter
operation, fix the deflector
F
to the flue support bracket
G
with 2 screws and connect the other end of
the exhaust pipe to the deflector collar
F
(if the collar is not already fitted it should be inserted on the
deflector and secured with 1 screw). Once the steam and fumes have been filtered by the carbon filter
(not provided, to be ordered separately) they are conveyed back to the kitchen through grid
H
.
19.
Carry out the electrical connection.
20.
Apply the flues and fix them with 2 screws (
20a
) to the flue support
G
(
20b
).
21.
Slide the bottom section of the flue in the special seat above the hood to completely cover the extraction
unit.
Refit the grease filter/s and check for correct hood operation.
INSTALLATION - ASSEMBLY INSTRUCTIONS
31833091.fm Page 5 Thursday, November 27, 2003 3:45 PM
5019 318 33091
AKR 950 - AKR 959
D F NL E
GB
P I GR
1.
Control panel.
2.
Grease filter.
3.
Halogen bulbs.
4.
Steam deflector.
5.
Telescopic flue.
To clean the grease filter
Wash the grease filter at least once a month.
1.
Disconnect the electrical power supply.
2.
Remove the grease filters -
Fig. 2
: pull the spring
release handle
(f)
downwards, then remove the
filter.
3.
After cleaning the grease filter refit in reverse
order, making sure the entire extraction surface
is covered.
Carbon filter Fitting and Maintenance
Fitting the carbon filter:
1.
Disconnect the electrical power supply.
2.
Remove the grease filter
(f - Fig. 2)
.
3.
Turn the side knobs 90° and then remove the
filter holder
(g - Fig. 3)
.
4.
Fit the carbon filter
(h - Fig. 3)
in the filter
holder
(i - Fig. 3)
.
5.
Refit the filter holder and secure it to the hood
with the screw
(g - Fig. 3)
.
6.
Refit the grease filter.
Carbon filter maintenance:
Unlike traditional carbon filters, this carbon filter can
be washed and reactivated.
With normal hood use, the filter should be cleaned
once a month. The best way to clean the filter is in a
dishwasher at the highest temperature possible,
using a normal dishwasher detergent. To avoid
particles of food or dirt settling on the filter during
washing and giving rise to unpleasant smells, it is
advisable to wash the filter on its own. After
washing, dry the filter in the oven at 100° C for 10
minutes to reactivate it.
The filter will retain its odour-absorbing capacity for
three years, after which it must be replaced.
Replacing bulbs
1.
Disconnect the electrical power supply.
2.
Use a small screwdriver or any other suitable tool
to prise off
(m-Fig. 4)
the lamp cover
(p-Fig. 4)
.
3.
Remove the burnt-out bulb.
Replace using 20 W max halogen bulbs only,
making sure not to touch them with your hands.
4.
Close the lighting unit (snap-close).
CONTROL PANEL
A.
Light ON/OFF switch.
B.
ON/OFF and speed 1 selector switch
(small amount of steam and fumes).
B+C.
Speed 2 selector switch
(medium amount of steam and fumes).
B+D.
Speed 3 selector switch
(large amount of steam and fumes).
ABCD
5
1
3
4
2
f1
f2
PRODUCT SHEET
31833091.fm Page 6 Thursday, November 27, 2003 3:45 PM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Whirlpool AKR 650 GY Program Chart

Category
Cooker hoods
Type
Program Chart
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI