2. DV8 OFFROAD
  3. Aluminum Rear Inner Fenders

DV8 OFFROAD Aluminum Rear Inner Fenders, INFEND-03RR Installation guide

  • Hello, I've reviewed the installation instructions for the DV8 OFFROAD INFEND-03RB(RR) JL Rear Inner Fenders. This document provides step-by-step instructions for removing the stock fenders and installing the new ones, which includes separating and mounting the driver and passenger side pieces. I'm ready to answer any questions you may have about the installation process.
  • What should I remove before installing the new inner fenders?
    What should I do after removing the packaging?
    What is the first step of installation?
……………………………………………………………………………………………………………………………………………………………………………
1. Remove your stock factory JL inner fenders and fenders flare from the
Jeep.
2. Remove your new DV8 rear inner fenders from their packaging.
3. Locate and separate the driver and passenger side pieces.
4. Install the top section of each piece using the provided hardware.
5.
6. With the provided rivnuts, install them into the holes on the front fenders
DV8 OFFROAD INFEND-03RB(RR)
JL REAR INNER FENDERS
In
…..0……………………………………000000000000000000000000000000000000000000000000000000000000000000
5. Place inner fender into wheel well. Make sure the vent is facing forward.
6. Hold up the front bolt hole against the vehicle and install provided nuts
and bolts. Continue to work your way to the center bolt and then the back
hole last.
7. Tighten bolts to ensure they are secure.
8. Reinstall fender flare.
If you have any questions or concerns, please feel free to call us at 951-680-
9595 or email info@dv8offroad.com
/