DV8 OFFROAD INFEND-04RB Installation guide

Type
Installation guide
GLADIATOR REAR INNER FENDERS
(INFEND-04RB)
1. Unpack your new rear inner fenders and inspect all items. You should have two inner
pieces (left and right) and two outer pieces (left and right) and a small box of
hardware.
2. Begin by joining each inner with the corresponding outer piece with supplied
hardware. NOTE: The lip on the smaller inner piece will sit behind the outer piece as
shown in the image below.
3. Once joined, place inner fender in inner wheel well. You will have to remove most
fenders to install.
4. Line up the holes on the front and back of the inner fender first. Attach loosely.
5. The rounded edge near the rear sits behind the lip of the wheel well as shown.
6. Attach last three bolts on the bottom of the inner fender with supplied hardware.
Tighten all hardware until inner fender secure.
If you have any questions, please email us at [email protected] or
call us at 951-680-9595
  • Page 1 1
  • Page 2 2

DV8 OFFROAD INFEND-04RB Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI