Danfoss SpeedUp Eco - Strongboard Carpet User guide
- Type
- User guide
Application sheet
SpeedUp Eco
Carpet
Strongboard carpet
1
2
3
4
5
1 Carpet ≥ 5 mm
2 Strongboard carpet 10 mm
3 SpeedUp Eco heat panel + FH composite pipe 30 mm
4 Support batten (30mm)
5 Load bearing panel ≥ 15 mm
6 Wood bre insulation - additional insulation 30 mm
7 SpeedUp Eco perimeter insulation
8 If necessary moisture barrier
Floor nish ≥ 5 mm Carpet
Construction height ≥ 90 mm Height including oor nish
Weight ~ 35 kg / m² Weight including oor nish
Thermal resistance R 1,26 m²K / W The minimum thermal resistance requirement of DIN EN 1264 is
fullled. For water table ≤ 5 m the R-value must be increased.
Thermal transmission coecient U 0,70 W / m²K In renovations and building extensions up to 50 m² U-value = 0.5
W/m²K must be maintained.
Always follow the planning data.
Design load ≤ 2,0 kN / m²
Point load (≥ 20 cm²) ≤ 1,0 kN Sum point load ≤ design load; please notice special heavy ob-
jects (aquaria etc.)
Impact subsonic noise reduction 22 dB Test value according to DIN ISO 140-8; applies to concrete slabs
thicker than 12 cm (DIN 4109: m’ > 276 kg/m²)
Application area
Residential spaces, hallways and attic spaces in residential buildings and hotel rooms.
Corresponds to categories A1, A2 and A3 of DIN 1055-3.
Requirements & special features
A level, smooth and structurally sound surface is necessary for full surface contact with
the heating elements (elevated requirements according to DIN 18202 Table 3, row 4).
Structural sealing according to DIN 18195 must be placed beneath the oor panel in
case of structures facing the ground, and otherwise on the unnished oor. Strongboard
Carpet and synthetics must be primed after it is layed. If necessary, provide construction
with additional sealing against moisture from below (vapour barrier/seal). Observe all
installation instructions and manufacturer’s instructions.
Additional insulation
30 mm wood bre insulation 150 kPa, alternatively: 20 mm GUTEX Thermosafe wd = 50
kPa. Renovation: 50 mm wood bre insulation 150 kPa, WLG 050 / 40 mm wood bre
insulation 50 kPa, WLG 040.
Construction
According to EnEV, EN 1264, DIN 1055, 4108 and 18202
Construction number 91
Technical Data Floors/ceilings facing unheated rooms or the ground
6
7
8
© Danfoss 11/2008
VA.CS.N1.02
Danfoss HES
-
1
Danfoss SpeedUp Eco - Strongboard Carpet User guide
- Type
- User guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Danfoss SpeedUp - Strongboard Carpet User guide
-
-
-
-
-
-
-
Danfoss SpeedUp - Strongboard tile and laminate User guide
-
-
