Midmark Elevance® Standard Delivery System Installation guide

English - 1

Console

Side Cover

Elevance™ Assistant’s Unit: Console Mounted

Installation

Language of origin: English

Step 3: On a LEFT side mounted console,

position mounting arm straight out

from the rear of the console.

Console

Cover

Step 4: Rotate ADAPTER clockwise before

loosely installing mounting screws.

Do not tighten mounting screws.

Stop Pin

Right side

pin hole

Left side

pin hole

Magnet

Bottom

Screw

003-2287-99 Rev. D (1/29/13)

Mounting

Screw

Leveling

Screw

Step 2: Install three leveling screws.

WARNING

Always disconnect chair from the power

source before removing any covers.

Failure to do so may result in personal injury.

Step 1: Remove magnetic side cover.

Loosen bottom screw and remove

inside console cover.

Tip: Console covers fit up under a lip at the top,

pull out from bottom, then down to remove.

Note:

The stop pin is factory set for a LEFT side mounted console (patient’s left).

Move the stop pin ONLY to install arm on a RIGHT side mounted console.

Adapter

Style G

midmark.com

English - 2

Assistant’s

Umbilical

Leveling

Screw

Step 5: Route the assistant’s umbilical and

vacuum line into the console.

Note: Take care not to kink the umbilical or vacuum line.

Step 6: Adjust three leveling screws to level

the mount arm assembly.

Tighten three mounting screws.

Mounting

Screw

Vacuum

Line

Style G

midmark.com

English - 3

Step 8: Connect like colored tubing in the console. Connect vacuum lines.

Note: No cover is required over tubing connections.

Keypad

Communication

Coupler

Optional

Heated

Syringe

Power

Console

Cover

Curing Light (option)

(red and black wires)

Ground

Wire

Quick Connects

Air

Water

Air

Water

Flow Control Knobs

Solids

Collector

HVE

Saliva

Ejector

Vacuum

Optional

Curing Light

Syringe

Tubing connections

Water (blue) /

Air (yellow)

Keypad

Communication

Line

Vacuum

Assistant’s Unit Tubing

Caution

Connect ground wire to ensure system ground continuity. Failure to do so may result in electric shock.

Step 7: Use velcro to mount keypad communication coupler to console wall and connect lines.

Connect any optional electrical components being used. Screw ground wire connections into

console. Place console cover over all electrical connections.

Style G

midmark.com

Color Page

English - 4

Installation Checklist

Test Verify the following:



1 Mounting arm and assistant’s unit are level.

2

Mount arm and assistant’s unit rotate and move

easily.

3

Assistant’s instruments work - no wires or tubing are

pinched by covers or mountings.

4

Wipe console and assistant’s unit with a soft dry cloth

to remove dirt or smudges.

5 (Optional) Curing light works.

Step 9: Install covers...

Install console cover over all electrical connections.

Install console side cover (align magnets).

Note: Be careful not to pinch or kink tubing or wires when

installing covers.

Step 10: Connect chair to power supply and

test assistant’s unit operation.

Style G

midmark.com

Page is loading ...

Midmark Elevance® Standard Delivery System Installation guide

Midmark Elevance® Standard Delivery System Installation guide

in other languages

Related papers

Other documents